Skip to end of metadata
Go to start of metadata

This page describes you how to control the 2N® IP intercom´s card reader signalization by the automation function.
 

The target scenario:

2N® IP intercom is integrated into a 3rd party access system, e.g. via wiegand interface, and does not contain any ID cards database. A user swipes his ID card on the ID card reader and 2N® IP intercom sends information about the ID card to the access system, that evaluates if the access is granted. If the access is granted, the access system sends HTTP command to the 2N® IP intercom to activate a switch and the "valid card" signalization on the ID card reader. If the access is not granted, the access system sends HTTP command to the 2N® IP intercom to activate the "invalid card" signalization on the ID card reader. If the relevant signalization is not activated on the ID card reader, the user has no feedback about used card validation.

 

2N® IP intercom FW & license

Icon

 

Please go to 2N® IP intercom´s web management - Hardware - Extenders - Card Reader and fill in a Module Name.

 

Please go to 2N® IP intercom´s web management - Services - Automation and create a new automation function.

 

The automation is based on Action OpenDoor that controls signalization of selected card reader module (fill in here the name of the module).

To activate this Action you can select some Event from the list, e.g. HttpTrigger (to use incoming HTTP command).

 

http://ip_address/enu/trigger/granted                 http://ip_address/enu/trigger/denied