Skip to end of metadata
Go to start of metadata

Use a PC equipped with any web browser to configure 2N® :

  • Launch your web browser (Internet Explorer, Firefox, etc.).
  • Enter the IP address of your intercom (http://192.168.1.100/, e.g.).
  • Log in using the Admin user name and 2n password.

You have to know the IP address of your device to log in to the integrated web server. By default, 2N® is switched into the dynamic IP address mode, i.e. it obtains the IP address automatically if a properly set DHCP server is available in your LAN. If no such DHCP server is available, you can operate 2N® in the static IP address mode.

If your device remains inaccessible (you have forgotten the IP address, or the LAN configuration has changed, for example), change the LAN settings using the buttons on the device.

IP Address Retrieval

Take the following steps to retrieve the 2N® IP address:

  • Connect (or, if connected, disconnect and reconnect) 2N® to the power supply.
  • Wait for the second sound signal .
  • Press the first quick dial button 5 times.
  • 2N® will read its IP address.
  • If the address is 0.0.0.0, it means that the intercom has not obtained the IP address from the DHCP server.

Note

Icon
  • Be sure to press the button sequence within thirty seconds after the sound signal for security reasons. Up to 2 s intervals are allowed between the presses.

Static IP Address Setting for 4-button models

Follow the instructions below to enable the static IP address mode:

  • Connect 2N® to the power supply (or, disconnect and reconnect it if already connected).
  • Wait for the first acoustic signal .
  • Press buttons 1, 1, 1, 2, 2, 3 sequentially.

  • The acoustic signal  indicates mode switching.
  • Wait until the device is restarted automatically.

Caution

Icon
  • The 1, 1, 1, 2, 2, 3 sequence must be entered within 30 seconds after the first sound signal for security reasons. The inter-digit delay may be 2 s at most.

The device will have the following network parameters after restart:

  • IP address – 192.168.1.100
  • Network mask – 255.255.255.0
  • Default gateway – 192.168.1.1

Dynamic IP Address Setting for 4-button models

Follow the instructions below to enable automatic getting of network parameters from the DHCP server:

  • Connect 2N® to the power supply (or, disconnect and reconnect it if already connected).
  • Wait for the first acoustic signal 
  • Press buttons 2, 1, 1, 2, 2, 3 sequentially.

  • The acoustic signal  indicates mode switching.
  • Wait until the device is restarted automatically.

Caution

Icon
  • The 2, 1, 1, 2, 2, 3 sequence must be entered within 30 seconds after the first sound signal for security reasons. The inter-digit delay may be 2 s at most.

2N® gets the IP address upon restart only if the DHCP server is configured properly.

Mode Switching with 1 or 2-Button Models

In case your 2N® device is equipped with 1 or 2 buttons, you can switch the modes using one button only.

  • Connect 2N® to the power supply (or, disconnect and reconnect it if already connected).
  • Wait for the first acoustic signal .
  • Press the first quick dial button 15 times.
  • The acoustic signal  indicates mode switching.
  • Wait until the device is restarted automatically.

Caution

Icon
  • The 15 times 1 sequence must be entered within 30 seconds after the first sound signal for security reasons. The inter-digit delay may be 2 s at most.

The static IP address mode will be switched into the dynamic IP address mode and vice versa upon restart.

  • No labels