2N® Helios IP Vario or 2N Helios IP Force with installed Card Reader module, firmware version 220.127.116.118.7 or newer.
Control of 2N® Helios IP lock via fingerprint scanned by MiY reader.
No special configuration, according to manual allows Wiegand output and disable Wiegand Passtrough.
Kindly use wiring as per User Manual or photo below:
2N® Helios IP configuration
Please configure all settings according to usual practice.
Enable card reader and set Wiegand to Input mode with no facility code change.
For 2N® Helios IP Vario please use wiring as follows
Please not that is is necessary to connect +5V output on the card reader module to both W1 and W0 data connectors of Wiegand interface, both through separate 1kOhm resistor.
For 2N® Helios IP Force the connection is similar, GND to GND, W1 to W1 and W0 to W0 between 2N® Helios IP and MiY. Also W1 and W0 have to be connected, but to +12V output of 2N® Helios IP Force card reader. As the voltage is used as pull-up powering of the interface, thanks to the voltage protection of Wiegand interface on 2N® Helios IP Force, higher voltage poses no danger.