Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

Version 1 Next »



This FAQ describes how to make factory reset of 2N® Lift1. In previous versions of lift communicators (2N® SingleTalk) it was only possible to ask tech. support to reset the password and set the device to default state by one of the parameters in programming menu. 2N® Lift1 has a new feature - now it is possible to make factory reset to default state by the user without assistance of 2N tech. support via jumper on PCB of the device. Below you will find a few steps which are describing how to do that.


  1. Release the screw and take off the front plastic plate of the unit.
  2. df


  • No labels