Skip to end of metadata
Go to start of metadata
  • Login to 2N® Access Commander via web interface.
  • Go to section Settings. 
  • In SYSTEM UPDATE section check the current version of your Access Commander.

          

 

System backup

Icon

Before next steps please always make a system backup via SAMBA or whole virtual machine backup as described below:

 


Find the right steps for your current version

 

If your current Access Commander version is 1.10.0 and higher

  • Please ensure the access to the Internet for Access Commander appliance.
    Be sure, that network configuration is set properly, you can follow this wiki page:
    Static IP address - How to set up static IP address in 2N® Access Commander.

  • In SYSTEM UPDATE section you will see a notification about available upgrade - you can read what is new in this version.
    The upgrade must be proceeded incrementally to the next sequential version. It is not possible to jump to the latest version directly.

       

  • To upgrade please follow this procedure

                 

 

 

           

 

  • When all necessary components are ready to update the system, you will see an upgrade console window to see the upgrade process status.

    Warning

    Icon

    During preparation of necessary components to update the system you can loose the access to the system.

    Please be patient and wait some minutes till the update process starts.

      

  • Now you can repeat the procedure up to the latest available version.
       

 

If your current Access Commander version is 1.9.1

Online upgrade is not available

Icon

It is not possible to upgrade the version 1.9.1 to the version 1.10.0 via online upgrade process due to the transition from Linux Debian version 7 to version 9.

Please follow this offline procedure (import of the database to a fresh new Access Commander 1.10.0) to uprade the system to the version 1.10.0.

Software Upgrade from Access Commander 1.9.1 to Access Commander 1.10

 

 

If your current Access Commander version is 1.9.0 and older

upgrade up to the version 1.9.1

Icon

It is possible to upgrade the Access Commander only up to the version 1.9.1 via the online procedure.

When you are on the version 1.9.1 successfully, you can proceed the procedures above to go to the version 1.10.0 and after that to the latest one sequentialy.

 

  • Please ensure the access to the Internet for Access Commander appliance.
    Be sure, that network configuration is set properly, you can follow this wiki page:
    Static IP address - How to set up static IP address in 2N® Access Commander.

  • In SYSTEM UPDATE section you will see a notification about available upgrade - you can read what is new in this version.
    The upgrade must be proceeded incrementally to the next sequential version. It is not possible to jump to the version 1.9.1 directly.