Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 4 Next »



This FAQ describes how to make factory reset of 2N® Lift1. In previous versions of lift communicators (2N® SingleTalk) it was only possible to ask tech. support to reset the password and set the device to default state by one of the parameters in programming menu. 2N® Lift1 has a new feature - now it is possible to make factory reset to default state by the user without assistance of 2N tech. support via jumper on PCB of the device. Also it is not possible to reset the password remotly. Below you will find a few steps which are describing how to do that.


  1. Release the screw and take off the front plastic plate of the unit.

  2. Once the device will be opened, you can use the configuration jumper marked in the picture below for the reset.7

  3. Now disconnect the device from the line and put the jumper from previous step to the two pins as shown in the picture below. Then connect the device again. After 5 second the device will be reseted, if you will turn around the device upside down, you will see LEDs signalling the reset. Once the device is reseted, you can disconnect it again and move the jumper to its original position. Now you can access programming menu of the device with default password. Also all the parameters will have the default values.


  • No labels