FAQ describes how to set 2N® SmartCOM PRO for AMS function by SMS message. 2N® SmartCOM PRO automatically detect M-Bus meters. Then reads data from M-Bus meters and store data in internal memory. 2N® SmartCom server with web interface readout  2N® SmartCOM PRO units and parse M-Bus messages to CSV files.

 

Tested with firmware (SCE_1-12-0-12-252). Ask 2N for this firmware or  access to test web server - contact your salesman or send a request go to https://support.2n.cz

 

Connect you 2N® SmartCom PRO unit to your 2N® SmartCom server. In this scenario will be used 2N® SmartCom test server with web interface.

Check, that your unit is connected to the server. (Web interface or in software 2N® Control panel)

 

 

Use software 2N® Control panel or AT commands and configure M-Bus port parameters.

2N® Control panel

In the page "Terminals", you can also set parameters of RS232,RS485,MBUS. Default M-Bus parameters are

Baudrate: 2400, Databits: 1, Parity: Even, Stop bit: 1, (Parameters of you M-Bus meter may be different – check it)

 

AT Comands

Settings M-Bus: speed 2400bd/s - data bits 8 – stop bits 1 – parity – even

at^scport2="baudrate",2400             Set baudrate

at^scport2="DATA_BITS",8              Set data bits

at^scport2="STOP_BITS",1             Set stop bits

at^scport2="PARITY",1                   Set even parity

at^scport2?                                    Check settings

at^scport2="save"                           Save settings

Enable AMS function (0 = AMS turned off)

at^scams="enable",1

Meter installation SMS

Performing this command deletes all the data from 2N®SmartCom PRO terminal memory as well as the meter reading configuration part. All the connected meters during the SMS processing will be available for the readout. The parameter interval is global for all installed meter by SMS.

SMS command:

SC AMSADD PWD=<password> QTY=<n> PORT=<port> PROTOCOL=<protocol> INT=<interval>

Parameters:   

SMS Answer:

QTY=n ERR=error_code ADDR=address#1, address#2,…, address#n

Parameters:      

 

 

Go to web interface to section "Terminals Monitoring" and synchronize your 2N® SmartCom PRO unit with 2N® SmartCom server.

Pres Start sync

Wait until synchronization is finished

 

In section "Meters" you can find information about your M-Bus meters

Results are in section - "Results" - For the access data (login, password) please contact your salesman or send a request go to https://support.2n.cz

 

or can be download by FTP client - loggin name:o2 pass:o2