Each 2N IP intercom can receive and send one multicast stream without any need for additional licenses. However, if you need your intercom to listen to more multicast sources – maybe up to five at once (or send multicast to different addresses), then you will need an Enhanced Integration or Gold license, which will allow you to set the required functionality via Automation. Such scenario may be useful, for example, in an area with several multi-storey buildings with several departments, where:
the intercoms in the 1st building will listen to multicast at the address 184.108.40.206 and port 11000,
the intercoms in the 2nd building will listen to multicast at the same address (or different – e.g. 220.127.116.11) and port 12000, etc.,
the intercoms on the 1st floor of the 1st building will listen, as well, to the multicast again at the same address (or different – e.g. 18.104.22.168) and port 11100,
the intercoms on the 2nd floor of the 1st building will listen, as well, to the multicast again at the same address (or different – e.g. 22.214.171.124) and port 11200, etc.,
the intercoms in the 1st department on the 1st floor of the 1st building will also listen to multicast, e.g. at address 126.96.36.199 and port 11110,
the intercoms in the 2nd department on the 1st floor of the 1st building will also listen to multicast, e.g. at address 188.8.131.52 and port 11120, etc.,
and at the same time the intercoms in all buildings, floors and departments will listen to multicast, e.g. at address 184.108.40.206 and port 10000.
In other words, in such scenario, each intercom listens on 4 different multicast addresses and ports at once.
There must be no odd port numbers used (e.g. 10001, 10003, 10011 etc.)
We will adjust the following parameters (eg. the multicast source that will be listened to by intercoms in all buildings together), thus enabling reception from one common source:
Receive IP Address: 220.127.116.11
Receive Port: 10000
Codec: the corresponding codec (which was selected for the respective multicast paging as well)
In the web interface of the intercom go to the Services > Automation section > select a free function > create and save the given automation (see the screen below).
Connect the required number of "StarMulticastRecv" blocks according to how many multicast addresses and ports, respectively, you want to be able to receive multicast streams from at once.
We can set up reception from up to 4 other sources in this way, as we have channels 0-3 available here, each of which can be used only once.
The example below shows what the automation in the intercom would look like on the 1st department of the 3rd floor in the 2nd building (according to the scenario described in the introduction).
Then reboot the intercom (System > Maintenance > Restart), because in this case we have the "Rebooted" action set as the trigger event.
Automation can be uploaded directly to the intercom's Automation – the file is here: Multicast.am
Note: All commands used in the Automation section are described in detail in our 2N IP intercom Automation manual where you can also find some examples. This manual is available on our web pages: